Comparison of different sequential extraction procedures for mercury fractionation in polluted soils

Environmental Science and Pollution Research - Three sequential extraction procedures (SEPs), modified Tessier, modified BCR, and CIEMAT, were compared for mercury fractionation in polluted soils....     

Low digestibility of phytate phosphorus,their impacts on the environment,and phytase opportunity in the poultry industry

Environmental Science and Pollution Research - Phosphorus is an essential macro-mineral nutrient for poultry, needed for the body growth, development of bones, genomic function, good...     

Correction to: Preparation of GO/MIL-101(Fe,cu) composite and its adsorption mechanisms for phosphate in aqueous solution

Environmental Science and Pollution Research - A Correction to this paper has been published: https://doi.org/10.1007/s11356-021-15526-6     

Comprehensive utilization of residues of Magnolia officinalis based on fiber characteristics

Journal of Material Cycles and Waste Management - The traditional Chinese medicinal plant Magnolia officinalis has a wide range of applications; including more than 200 kinds of patented Chinese...     

Estimating sampling frequency in pollen exposure assessment over time

A time series model was fitted to the pollen concentration data collected in the Greater Cincinnati area for the Cincinnati Childhood Allergy and Air Pollution Study (CCAAPS). A traditional time series analysis and temporal variogram approach were applied to the regularly spaced databases (collected in 2003) and irregularly spaced ones (collected in 2002), respectively. The aim was to evaluate the effect of the sampling frequency on the sampling precision in terms of inverse of standard error of the overall level of mean value across time. The presence of high autocorrelation in the data was confirmed and indicated some degree of temporal redundancy in the pollen concentration data. Therefore, it was suggested that sampling frequency could be reduced from once a day to once every several days without a major loss of sampling precision of the overall mean over time. Considering the trade-offs between sampling frequency and the possibility of sampling bias increasing with larger sampling interval, we recommend that the sampling interval should take values from 3 to 5 days for the pollen monitoring program, if the goal is to track the long-term average.     

内螺纹变截面铜管拉伸工艺的研究

此文提出了内螺纹变截面铜管分段拉仲一次成形新工艺,并就工艺因素对该管拉伸成形的影响进行了试验研究,从而为合理制订成形工艺提供了依据。     

亲水性多孔载体在流化床中的生物膜形成过程分析

采用实验制备的一种新型亲水性多孔聚合物作为流化床反应器中生物膜附着生长的载体,实现流态化水力条件下的生物挂膜过程.在3个结构尺寸相同的流化床反应器中考察了接种污泥浓度、进水有机负荷及载体粒径对亲水性多孔载体生物挂膜量的影响,试验结果表明,接种污泥浓度为30 g VSS/L、进水TOC值为350 mg/L、载体粒径为5～8 mm时载体表面的附着生物量最大,反应器运行12 d的载体附着生物量达到4.45 g VSS/L,膜结构稳定,表现出较活性污泥法更高的活性.在进水TOC、氨氮浓度分别为350 ms/L、50 mg/L,HRT为6 h的情况下,两者的去除率分别达到了97.1%和64.3%,表明载体上的生物膜对污水中TOC及氨氮的去除表现出高效率.挂膜后载体表面上的微生物以丝状菌为主,孔壁上的微生物以球菌和杆菌为主要生物相,证明载体内外表面皆适宜微生物的生长,并且形成合理的生物相分布.     

地震救灾过渡安置点避雷针的布设选点及安装要求

"5.12"汶川8级大地震波及范围很大,给陕西省部分地方造成了不小的损失.灾后,汉中、宝鸡的地震救灾过渡安置点由于缺乏防雷电保护,打雷时有遭受雷电灾害的可能,亟需要对其采取防雷电保护措施.对救灾过渡安置点采用独立避雷针进行防护,该措施安全可靠、简便易行,就成为首选,其布设选点要科学、规范,可使其效益最大化,避雷针的制作和安装应符合技术标准要求,做到牢固可靠,在施工中要因地制宜.综合考虑,始终把安全和牢靠放在首位.     

计算机模拟研究UO2+2在人体细胞液的形态分布

建立了由多种金属离子和小分子配体组成的多相细胞液热力学平衡模型.模拟研究了UO2 2在组织液和细胞液的形态分布及CO2-3、氨三乙酸（NTA）和乙二胺四乙酸（EDTA）浓度对细胞液中UO2 2形态分布的影响.在组织液中,正常生理pH下,当各形态UO2 2总摩尔浓度 [U]= 1.0×10-6 mol/L 或[U]=1.0×10-3 mol/L时,UO2 2均主要以[UO2(CO3)3]4-和[UO2(CO3)2]2-形态存在.在细胞液中,当[U]=1.0×10-6 mol/L时,UO2 2主要以[UO2(CO3)3]4-和[UO2(CO3)2]2-存在；当[U]=1.0×10-3 mol/L,pH为6.0～6.8时,细胞液中存在大量的固相(UO2)3(PO4)2·4H2O,当pH为6.8～7.4时,UO2 2主要以[UO2(CO3)3]4-、[UO2(CO3)2]2-和[(UO2)2CO3(OH)3]-存在.细胞液中(UO2)3(PO4)2·4H2O含量随[U]升高而增加.通过调节细胞液pH和增加细胞液CO2-3浓度均能降低其固相UO2 2配合物含量.在细胞液中增加NTA会增加(UO2)3(PO4)2·4H2O含量,当添加EDTA时会显著降低(UO2)3(PO4)2·4H2O含量.     

金属加工过程中应力状态的分析方法

分析简单地拉伸、压缩和扭转的情况时,应力状态能容易地被确定.但是,实际上在金属加工过程中材料是承受复杂的应力状态,在模具——工件接触面上增加有摩擦力.而且,这些应力和摩擦力一般地沿着接触面变化.准确的计算或预测载荷、力、应力和温度,不但对设计适宜的设备是重要的,而且对研究工艺期间材料的变化过程也是重要的.本文将讨论材料变形过程中所运用的主要分析方法及其优缺点.